The following matters should be noted when installing socket-welded forged steel Wear-Resistant Ball Valve:
1. Do not allow the
Wear-resistant Ball Valve to bear weight in the pipeline. Large Wear-resistant
Ball Valve should be supported independently so that they are not affected by the pressure generated by the pipeline system.
2. During installation, pay attention to the direction of the medium flow should be consistent with the direction of the arrow on the valve body.
3. Lift-type vertical flap Wear-resistant Ball Valve should be installed on vertical pipelines.
4. Lift-type horizontal flap Wear-resistant Ball Valve should be installed on horizontal pipelines.
Waist-type lift Wear-resistant Ball Valve should be installed on horizontal pipelines.
Swing Wear-resistant Ball Valve can be installed horizontally or vertically. The valve disc of the swing Wear-resistant Ball Valve rotates around the rotating shaft, and its fluid resistance is generally smaller than that of the lift Wear-resistant Ball Valve. It is suitable for larger diameter occasions, and the installation position is not restricted. It is usually installed in horizontal pipelines. It is suitable for larger diameter occasions.
Multi-flap Wear-resistant Ball Valve or large-diameter silent Wear-resistant Ball Valve should be used on large-diameter water pipes to stagger the closing time of each flap or close slowly to reduce the destructive effect of water hammer.
